| Featured Space and Satellite Products |
|
|
| 3-Axis Inertia Measurement Unit for Satellites and Launch Vehicles | |
Inertial Measurement Unit
from Safran Group
|
| The STIM377H from Safran Group is an Inertial Measurement Unit that consists of 3 high-accuracy MEMS-based gyros, 3 high-stability accelerometers and 3 inclinometers in a miniature package. It features a gyro that is based on Safran ButterflyGyro using a single-crystal silicon technology with an electronically calibrated axis alignment. It is ideal for satellites, military land navigators, satellite launchers, launch vehicles, missile systems, remote weapon systems, DIRCM, and target acquisition systems. |
| |
Download Datasheet
Product Details | |
|
|
|
| 100 V Radiation Hardened Solid-State Relay | |
Space Qualified Solid State Relay
from Infineon Technologies
|
| The RDHA710SE10A2QK from Infineon Technologies is a Space Qualified Solid State Relay with a contact resistance of 0.070-0.145 ohms and a maximum output voltage of 100 V. It has an output capacitance of 2000 pF and a thermal resistance of 1.7 degrees C/W. The relay has a hermetically sealed package with total dose capability of up to 100kRads (Si) and optically coupled. It has an 8-pin surface mount international rectifier’s R5 technology and actuated by standard logic inputs. |
| |
Download Datasheet
Product Details | |
|
|
|
| 64W Ku-Band GaN SATCOM Block Upconverter for SATCOM Uplinks | |
Block Upconverter
from Comtech Xicom Technology
|
| The Bobcat 64Ku from Comtech Xicom Technology is a SATCOM Block Upconverter that converts an input IF frequency of 950-1700 MHz to an output RF frequency of 13.75-14.5 GHz. This GaN technology based BUC has an external LO reference frequency of 10 MHz. The BUC supports Ethernet and RS-232 interfaces for monitoring and control. It has a rugged MIL-STD-810 certified module that weighs 2.54 Kg and measures 6.8 x 4.4 x 4.2 inches. This Ku-band Block Upconverter is ideal for satcom uplinks. |
| |
Download Datasheet
Product Details | |
|
|
|
| 78 Ah Space-Qualified Li-ion Rechargeable Battery | |
Satellite Battery
from EnerSys
|
| The ABSL 8s52p 28V 78Ah from EnerSys is a Satellite Battery with a configuration of 8s52p. It has a nameplate capacity of 78 Ah. It is qualified for the Thai Earth Observation System (THEOS) spacecraft and also be used to isolate the battery from the spacecraft depending on mission requirements. It operates without the need for cell-balancing electronics and the design has been utilized for a variety of applications from civilian to commercial applications, especially for Earth observation spacecraft. |
| |
Download Datasheet
Product Details | |
|
|
|
| DC-18 GHz Space-Qualified Fixed Attenuator | |
Space Qualified Fixed Attenuator
from Cinch Connectivity Solutions
|
| The SQA-0180-01-SMA-02 from Cinch Connectivity Solutions is a Space Qualified Fixed Attenuator that operates at a frequency range of DC-18 GHz. It has a stainless steel passivated finish construction with the highest level of screening compatible and has a space qualification of MIL-DTL-3933 level T which is suitable for all space flight applications. It has a space flight history of different flights such as Emirates Mars Mission, Parker Solar Probe, Europa Clipper, One Web, and GPS Satellites. |
| |
Download Datasheet
Product Details | |
|
|
|
| Extended C-Band Test Loop Translator for Signal Transmission | |
Test Loop Translator
from Peak Communications
|
| The TLT585 from Peak Communications is a Test Loop Translator that translates an input C-band frequency of 5.85-6.65 GHz to an C-band frequency of 3.4-4.2GHz. It requires a power supply of 90-264 VAC. It features full alarm monitoring and an optional manual attenuator that is continuously variable from 0-30 dB. The test loop translator weighs 4.5 Kg and measures 19 × 1.75 × 15.7 inches. It is designed to take a sample of the transmit signal and convert it to a frequency at which it can be monitored or analyzed. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by Convergence India Expo 2025 | | Convergence India Expo 2025 | | Establishing a dynamic platform for global connections, innovation, and the forging of enduring international partnerships, the Convergence India Expo 2025 edition serves as a melting pot for professionals, digital trailblazers, international businesses, and government leaders across IT, ICT, Broadcast, IoT, Fintech, and Embedded Technology. Anticipating over 55,000 industry visitors, 1,200 brands, and participants from 40+ countries, it's your perfect platform to connect with potential clients and tech luminaries. Click here to learn more | | | |
|
|
| 3.3 V Hermetically Sealed High Gain Optocouplers | |
Space Qualified Optocoupler
from Broadcom
|
| The 5962-0822702H from Broadcom is a Space Qualified Optocoupler with a forward voltage range of 1-1.8 V. It features a GaAsP light emitting diode that is optically coupled to an integrated high gain photon detector and has a common mode transient immunity of 500-1000 V/us. It is designed for military and aerospace, telephone ring detection, microprocessor system interface, medical, and life critical systems, isolated I/O line receiver, voltage level shifting, and logic ground isolation applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| 2-40 GHz Dual-Directional Coupler for Mobile Satellite Applications | |
Space Qualified Coupler
from Mini Circuits
|
| The ZDDC20-K0244 from Mini Circuits is a Space Qualified Coupler with an operating frequency range of 2-40 GHz. This dual-directional coupler has a coupling of 20 dB and a coupling flatness of +/- 0.4-1 dB. The coupler has a return loss of 11.7-35 dB (In & Thru) and 11.7-33 dB (coupling). It has a power handling capacity of up to 20 W and requires a DC current supply of 0.63 A. It has a mass of 120 g with 2.92 mm female connector and is ideal for 5G, mobile, fixed satellite, and lab applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| 750 W C-Band Antenna Mount TWT Amplifiers | |
SATCOM Amplifier System
from Spacepath Communications
|
| The STA6175 from Spacepath Communications is a SATCOM Amplifier System with a frequency range of 5.850-7.025 GHz. It has a gain adjustment range of 30 dB and has a phase noise profile of 10 dB below IESS requirement. It requires an AC voltage supply of 200-240 V. It features an advanced cooling design that enables operation at +60°C and in direct sunlight and supports RS485, RS232, and Ethernet. The amplifier system weighs 25 Kg and measures 588 x 254 x 280 cm. |
| |
Download Datasheet
Product Details | |
|
|
|
| Ariane Booster Attachment and Separation Mechanism | |
Attach and Release Mechanism
from Kongsberg
|
| The Ariane 5 DAAV from Kongsberg is a Attach and Release Mechanism with a flight limit load of 3700kN. The DAAV high performance spherical bearings included in a highly sophisticated mechanism, transmit the loads from the Ariane 5 booster motor (EAP) to the Ariane 5 main stage (EPC) throughout the booster life. The functions of the DAAV are to transmit loads between the EAP and the EPC throughout the launch vehicle’s life, assist in the EAP/EPC separation upon receipt of a pyrotechnical order. |
| |
Download Datasheet
Product Details | |
|
|
|
| 10-20 MHz Space OCXO for Telecom and Test Applications | |
Space Qualified Oscillator
from Rakon Limited
|
| The ROD5242T1 from Rakon Limited is a Space Qualified Oscillator with a nominal frequency of 10-20 MHz. It has a 48-hour holdover performance of ±1.5 µs and a supply voltage stability of ± 0.5 ppb. The oscillator requires a supply voltage of 3.3 V and has a power consumption of 3-7.5 W. This oscillator measures 52 x 42 x 14 mm of package size and is an ideal for edge grand masters, DU/CU/servers, cell-site routers, front-haul switches, NIC time cards, test equipment and GNSS modules. |
| |
Download Datasheet
Product Details | |
|
|
|
| 2.4 Meter Glass Fiber Flyaway Antenna | |
SATCOM Antenna
from Sat-Lite Technologies
|
| The 2422 Celero from Sat-Lite Technologies is a SATCOM Antenna that supports multi-band C, X and Ku-band frequencies. This antenna has an isolation of -110 to -35 dB. It features a 2.4 meters glass fiber reflector which is configured as 4-piece segmented that is designed to provide exceptional performance in a lightweight package. It has a continuous azimuth of +/- 360 degrees and an elevation of 5-90 degrees of reflector boresight. It has a reflector mass of 88.6 kg and measures 56 x 50 x 20 inches. |
| |
Download Datasheet
Product Details | |
|
|
| Sponsored by Convergence India Expo 2025 | | |
|
|
| Two Axis Thruster Gimbal Xenon Propellant | |
Gimbal
from Moog
|
| The Thruster Gimbal from Moog that can be configured for wide rotation on both axes with a total rotational range of +/- 36 degrees (X & Y axis). It features dual axis gimbal driven by rotary actuators for cross-axis positioning, a potentiometer for position telemetry, and space-qualified stepper motors with harmonic drive transmission. It weighs 11 lbs and measures 8.75 x 5 x 5 inches. This two axis thruster gimbal with xenon propellant has a on-orbit life of 15 years and offers significant flight heritage. |
| |
Download Datasheet
Product Details | |
|
|
|
| 50 Nms Reaction Wheel for Highline Applications | |
Reaction Wheel
from Astrofein
|
| The RW3000 from Astrofein is a Space-Qualified Reaction Wheel that is designed for Highlines and has a lifetime of up to 15 years with an integrated wheel drive electronics for latch-up protection. This space-qualified reaction wheel has an angular momentum of 50 Nms and a nominal torque of 0.2 Nm. It has a rotation speed range of 4000 rpm and supports RS485 and CAN interfaces for control. The RW3000 reaction wheel by Astrofein has a mass of 9 kg and measures 370 x 370 x 120 mm. |
| |
Download Datasheet
Product Details | |
|
|
|
| 17.3-21.2 GHz K-Band Block Downconverter for Satellite Operations | |
Block Downconverter
from ETL Systems
|
| The FN-D-KXL1-24424AA from ETL Systems is a Block Downconverter that converts an input frequency of 17.3–21.2 GHz to an output frequency of 1150-2150 MHz. It requires an AC input supply of 85-264 V and has a power consumption of 150 W. This block converter weighs less than 10 Kg. It has typical applications include teleports and Earth stations, satellite operations, government and defense applications, telemetry, tracking and command, and high resilience applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| 50 W Radiation Hardened Isolated Power Converter | |
DC to DC Converter
from Microchip Technology
|
| The SA50-120-12S-A-P from Microchip Technology is a DC to DC Converter that converts a DC input voltage of 120 V to a DC output voltage of 12 V. This isolated DC-DC converter is based on forward converter topology and features patented magnetic feedback. The converter has a radiation tolerance TID of 100krad (Si). It has a low mass of 120 g and measures 3.055 x 2.055 x 0.5 inches. The converter is based on flight-proven technology with a high MTBF and is ideal for space and military applications. |
| |
Download Datasheet
Product Details | |
|
