| Featured Space and Satellite Products this Week |
|
|
| Space Qualified GPS Bandpass Filter | |
Space Qualified RF Filter
from Mercury Systems
|
| The L1355 from Mercury Systems is a Space Qualified RF Filter with a passband frequency of 1575.42 MHz. This GPS bandpass filter has a passband ripple of 0.1 dBc and a 3 dB bandwidth of 1555.42- 1595.42 MHz. The filter features a cavity design and has an ultra-low insertion loss of 0.25 dBa. It supports SMA female input and SMA male output connectors and measures 0.6 x 1.5 x 1.6 inches. The filter is designed for spacecraft and booster applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| Solar Array Drive Assembly for Space Missions | |
Solar Array Drive Mechanism
from Moog
|
| The Type 3/5 Solar Array Drive Assembly from Moog is a Solar Array Drive Mechanism with an output torque of 400 lb-in. This assembly has an unpowered holding torque of 200 lb-in and a powered holding torque of 500 lb-in. The assembly has a motor winding resistance of 72 Ohms phase-to-phase and a potentiometer resistance of 5000 Ohms. It has a low weight of less than 11 lbs and is designed to meet mission requirements for different space missions. |
| |
Download Datasheet
Product Details | |
|
|
|
| 75 cm Ku-band Satellite Terminal | |
Satellite Terminal
from Cubic Corporation
|
| The FLEX from Cubic Corporation is a Satellite Terminal with a transmit frequency range of 13.75-14.50 GHz and a receive frequency range of 10.95-12.75 GHz. This Ku-band terminal has a G/T of 17 dBi/K. It has an amplifier rated power of 25 W and requires an input supply of 10-42 VDC. It is suitable for use in austere environments and is ideal for defense and first responders that need to establish satellite communications in difficult-to-reach locations. |
| |
Download Datasheet
Product Details | |
|
|
|
| 50 W Space Grade Isolated DC-DC Power Converter | |
DC to DC Converter
from Microchip Technology
|
| The SA50-120-5-12T-A-P from Microchip Technology is a Radiation-Hardened DC-to-DC Converter that converts a DC input voltage of 86-158 V to a DC output voltage of 5-12 V. This rad-hardened converter delivers an output power of up to 50 W and has an efficiency of up to 85% at full load conditions. It is based on forward converter topology and features patented magnetic feedback. It has a line regulation of 10-120 mV and a load regulation of 50-400 mV. |
| |
Download Datasheet
Product Details | |
|
|
|
| Light Stimulator for Sun Sensors OGSE for TVAC | |
Sun Sensor Simulator
from Solar MEMS
|
| The LS3 from Solar MEMS is a Sun Sensor Simulator that is based on a controlled and stable light source to stimulate optical sensors. This optical ground support equipment has a beam size diameter of 25 mm and a focal length of 18 mm. It operates without touching the sensor or the platform and includes a 19-inch controller and up to 3 optical heads per unit. It uses M6 for rod and/or tripod for optical head mounting and is designed to work under TVAC. |
| |
Download Datasheet
Product Details | |
|
|
|
| Embedded L-Band Dual Input Beacon Receiver Module | |
Satellite Beacon Receiver
from AVCOM
|
| The BR-MOD-1-9-A-2S from AVCOM is a Satellite Beacon Receiver with an L-band input frequency range of 930-2175 MHz. It has a tuning step size value of 1 kHz steps and an input level of -100 to -10 dBm. The beacon receiver can lock and track CW, BPSK, and CEPT on DVB carrier signals and has a tracking level of 39 dB-Hz. The receiver has a search/track rate of 10/25 Hz. It is ideal for on-the-move, fixed-site, and embedded applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| 39 mN Hall Effect Thruster for SmallSats | |
Spacecraft Thruster
from Busek
|
| The BHT-600 from Busek is a Spacecraft Thruster that is suited for ESPA-class spacecraft. This Hall Effect thruster has a nominal thrust of 39 mN, a discharge power of 600 W and a specific impulse of 1300-1500 sec. It is compatible with propellants such as Xenon, Krypton, and Iodine and has a throttle range of 300-800 W. The thruster has a mass of 2.6 Kg and a cathode mass of 0.2 Kg. It is ideal as primary propulsion for small satellites. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1:2 Redundant Line Amplifier System | |
SATCOM Amplifier System
from L3Harris Narda-MITEQ
|
| The RL2-095145 from Narda-MITEQ is a SATCOM Amplifier System with a frequency range of 0.95-1.45 GHz. This redundant line amplifier system has a minimum gain of 30 dB and a power output of 10 dBm. It has a maximum noise figure of 8 dB (Above 14.5 GHz) and an isolation of 50 dB. The amplifier system weighs 9.17 Kg and is designed to ensure continuous operation without disruption of signal transmission for satellite communications. |
| |
Download Datasheet
Product Details | |
|
|
|
| 2.8 mH Space Grade Current Sense Transformer | |
Space Qualified Power Transformer
from Vanguard Electronics
|
| The SCS101 from Vanguard Electronics is a Space Qualified Power Transformer with an inductance of 2.8 mH. This transformer has a peak withstanding current of 6 A and a direct current resistance of 1 Ohm. It has a turns ratio of 1:50 and requires a primary voltage of 20 V. It features tin-lead terminations and welded internal connections. It has a minimum dielectric withstanding AC voltage of 500 V and a minimum insulation resistance of 10K MOhms. |
| |
Download Datasheet
Product Details | |
|
|
|
| 32 W Ka-Band GaN SATCOM Block Upconverter | |
Block Upconverter
from Comtech Xicom Technology
|
| The Bobcat 32Ka from Comtech Xicom Technology is a SATCOM Block Upconverter that converts an input IF frequency of 1000-2000 MHz to an output RF frequency of 30.0-31.0 GHz. It requires a DC supply of 22-56 V and draws a DC power of 160 W. It has a noise power of -76 dBW/4 kHz (transmit band). The BUC has spurious levels of -60 dBc and a phase noise of -103 dBc/Hz at 1 MHz offset. The BUC is ideal for satcom uplinks. |
| |
Download Datasheet
Product Details | |
|
|
|
| 1.0-26.5 GHz 180 Degree Space Qualified Hybrid Coupler | |
Space Qualified Coupler
from KRYTAR
|
| The 4010265-SQ from KRYTAR is a Space Qualified Coupler with an operating frequency range of 1.0-26.5 GHz. This hybrid coupler has an amplitude imbalance of +/- 1.0-1.5 dB and a phase imbalance of +/- 16 degrees. The coupler is suitable for applications such as space, electronic warfare (EW), commercial wireless, SATCOM, radar, signal monitoring and measurement, antenna beam forming, and EMC testing environments. |
| |
Download Datasheet
Product Details | |
|
|
|
| 128K x 8 Radiation Hardened Static RAM | |
Space Qualified Memory
from Honeywell Aerospace
|
| The HLX6228 from Honeywell Aerospace is a Space Qualified Memory that is configured as 128K x 8. It is a high performance 131,072 word x 8-bit static random access memory that is fabricated with RICMOS IV Silicon on Insulator (SOI) radiation-hardened technology. It requires a VDD power supply of 3.3 V and has a power consumption of 360 mW at 40MHz operation. It is suitable for use in systems operating in radiation environments. |
| |
Download Datasheet
Product Details | |
|
|
|
| Space Qualified Single Board Computer | |
Satellite On-Board Computer (OBC)
from ZIN Technologies
|
| The SBCFA1000 from ZIN Technologies is a Satellite On-Board Computer based around a Leon3FT processor with a high-performance dual-precision IEEE-754 FPU. Its parts are fully tested and qualified per EEE-INST-002 and radiation hardened up to 100 Krad TID. It was designed for the radiation environment of NASA’s Multiscale Magnetospheric Mission. It measures 5 x 4 inches and is ideal for data processing or spacecraft control applications. |
| |
Download Datasheet
Product Details | |
|
|
|
| S-Band Satellite Test Loop Translator for Testing Satcom Links | |
Test Loop Translator
from Advantech Wireless Technologies
|
| The ATLT- S100 from Advantech Wireless Technologies is a Test Loop Translator that converts an S-band RF input frequency of 2025-2120 MHz to an RF output frequency of 2199-2303 MHz. It has a maximum conversion gain of -35 dB and a gain adjustment of 40 dB. It requires a supply voltage of 90-265 VAC and has a power consumption of 20 W. It measures 482.6 x 44.5 x 508 mm and is designed for testing satellite communications links. |
| |
Download Datasheet
Product Details | |
|
|
|
| 750 KHz to 800 MHz Space Level Clock Oscillator | |
Space Qualified Oscillator
from Wi2Wi
|
| The FP4 Series from Wi2Wi is a Space Qualified Oscillator with a frequency range of 750 KHz to 800 MHz. This oscillator has an output duty cycle of 45-55 %. It has a phase jitter of 0.1-1.0 psec and a phase noise of up to -110 dBc/Hz. It has a rad-tolerance TID of up to 100 Krad and a single event latch-up immunity of 60 MeV-cm2/mg. It utilizes a premium swept quartz crystal resonator in a 4-point mount and is designed for low-to-mid orbit applications. |
| |
Download Datasheet
Product Details | |
|
